extended Optional. Enter the keyword extended to send extendedcommunity attribute.standard Optional. Enter the keyword standard to send standardcommunity attribute.Defaults Not configured and COMMUNITY attributes are not sent to neighbors.Command Modes ROUTER BGPCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.3.11.1 Introduced on the Z9000.7.8.1.0 Introduced on the S-Series.7.7.1.0 Introduced on the C-Series.Usage Information To configure a COMMUNITY attribute, use the set community command in ROUTE-MAP mode.Before using this command, you must execute the clear ip bgp command.neighbor shutdownDisable a BGP neighbor or peer group.C9000 SeriesSyntax neighbor {ip-address | peer-group-name} shutdownTo enable a disabled neighbor or peer group, use the neighbor {ip-address |peer-group-name} no shutdown command.Parameters ip-address Enter the IP address of the neighbor in dotted decimal format.peer-group-name Enter the name of the peer group to disable or enable all routerswithin the peer group.Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)Command Modes ROUTER BGPBorder Gateway Protocol 487
