to 4294967295. The default is 604800. The maximum valuemeans that the preferred lifetime and does not expire.Command Modes INTERFACEINTERFACE (BATCH MODE)Command History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.8.3.2.0 Introduced on the E-Series TeraScale, C-Series, and S-Series.Usage Information By default, all prefixes configured as addresses on the interface are advertised. Thiscommand allows control over the individual parameters per prefix; you can use thedefault keyword to use the default parameters for all prefixes. If a prefix has beenconfigured with lifetime parameter values, the default values cannot be applied usingthe ipv6 nd prefix default no-autoconfig command. Use this command inthe Configuration Terminal Batch mode to advertise in a dual-homing setup.ipv6 routeEstablish a static IPv6 route.C9000 SeriesSyntax ipv6 route ipv6-address prefix-length {ipv6-address | interface |interface ipv6-address} [distance] [tag value] [permanent][weightweight-value [vrf vrf-name]To remove the IPv6 route, use the no ipv6 route ipv6-address prefix-length{ipv6-address | interface | interface ipv6-address} [distance]IPv6 Basics 1280
