dcbx versionConfigure the DCBX version used on the interface.C9000 SeriesSyntax dcbx version {auto | cee | cin | ieee-v2.5}To remove the DCBX version, use the no dcbx version command.Parameters auto | cee | cin |ieee-v2.5Enter the DCBX version type used on the interface, where:• auto: configures the port to operate using the DCBXversion received from a peer.• cee: configures the port to use CDD (Intel 1.01).• cin: configures the port to use Cisco-Intel-Nuova (DCBX1.0).• ieee-v2: configures the port to use IEEE 802.1az (Draft2.5).Defaults AutoCommand Modes INTERFACE PROTOCOL LLDPCommand History This guide is platform-specific. For command information about other platforms, seethe relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9 (0.0) Introduced on the C9010.9.7(0.1) Introduced on the S3048-ON and S4048-ON.9.7(0.0) Introduced on the S6000-ON.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.12.0 Introduced on the S4810.8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.Usage Information DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.Data Center Bridging (DCB) 710
