snmp-server hostConfigure the recipient of an SNMP trap operation.C9000 SeriesSyntax snmp-server host ip-address | ipv6-address | hostname [vrfmanagement traps | informs] [version 1 | 2c | 3] [auth | no auth |priv] [community-string] [udp-port port-number] [notification-type]To remove the SNMP host, use the no snmp-server host ip-address | ipv6-address |hostname [vrf management traps | informs] [version 1 | 2c | 3] [auth | noauth | priv][community-string] [udp-port number] [notification-type] command.Parameters ip-address Enter the keyword host followed by the IP address of the host(Configurable hosts are limited to 16).ipv6-address Enter the keyword host then the IPv6 address of the host in thex:x:x:x::x format.NOTE: The :: notation specifies successive hexadecimalfields of zero.hostname Enter the keyword host followed by the name of a host alreadyconfigured and recognized by the switch.vrf management Enter the keyword vrf followed by the keyword managementto specify that management vrf will be used to send traps andinforms.traps (OPTIONAL) Enter the keyword traps to send trap notificationsto the specified host. The default is traps.informs (OPTIONAL) Enter the keyword informs to send informnotifications to the specified host. The default is traps.version 1 | 2c | 3 (OPTIONAL) Enter the keyword version to specify the securitymodel then the security model version number 1, 2c, or 3:• Version 1 is the least secure version.• Version 3 is the most secure of the security modes.• Version 2c allows transmission of informs and counter 64,which allows for integers twice the width of what isnormally allowed.The default is version 1.auth (OPTIONAL) Enter the keyword auth to specify authenticationof a packet without encryption.Simple Network Management Protocol (SNMP) and Syslog 2057
