neighbor activateThis command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI.C9000 SeriesSyntax neighbor {ipv6-address | peer-group-name} activateTo disable, use the no neighbor {ipv6-address | peer-group-name}activate command.Parameters ipv6-address Enter the IPv6 address in the x:x:x:x::x format.NOTE: The :: notation specifies successive hexadecimalfields of zeros.peer-group-name Identify a peer group by name.activate Enter the keyword activate to enable the identified neighboror peer group in the new AFI/SAFI.Defaults Disabled.Command Modes ROUTER BGPV6-ADDRESS FAMILYCommand History Version Description9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.2.1.0 Introduced on the E-Series ExaScale.7.4.1.0 IntroducedUsage Information By default, when you create a neighbor/peer group configuration in the Router BGPcontext, it is enabled for the IPv6/Unicast AFI/SAFI. By using activate in the new context,the neighbor/peer group is enabled for AFI/SAFI.neighbor advertisement-intervalSet the advertisement interval between BGP neighbors or within a BGP peer group.C9000 SeriesSyntax neighbor {ipv6-address | peer-group-name} advertisement-intervalsecondsBorder Gateway Protocol 597
