IPv6 Access Control Lists (IPv6 ACLs)IPv6 ACLs and IPv6 Route Map commands are supported on Dell Networking operating system.NOTE: For IPv4 ACL commands, refer to the Access Control Lists (ACL) chapter.Important Points to Remember• Certain platforms require manual CAM usage space allotment. For more information, see the cam-aclcommand.• Egress IPv6 ACL and IPv6 ACL on the Loopback interface is not supported.• Reference to an empty ACL permits any traffic.• ACLs are not applied to self-originated traffic (for example, Control Protocol traffic not affected by IPv6ACL because the routed bit is not set for Control Protocol traffic and for egress ACLs the routed bit mustbe set).• You can use the same access list name for both IPv4 and IPv6 ACLs.• You can apply both IPv4 and IPv6 ACLs on an interface at the same time.• You can apply IPv6 ACLs on physical interfaces and a logical interfaces (Port-channel/VLAN).• Non-contiguous masks are not supported in source or destination addresses in IPv6 ACL entries.• Because the prefix mask is specified in /x format in IPv6 ACLs, inverse mask is not supported.Topics:• cam-acl• cam-acl-egress• clear counters ipv6 access-group• deny (for IPv6 ACLs)• deny icmp (for Extended IPv6 ACLs)• deny tcp (for IPv6 ACLs)• deny udp (for IPv6 ACLs)• ipv6 access-list• ipv6 control-plane egress-filter• permit (for IPv6 ACLs)• permit icmp (for IPv6 ACLs)• permit tcp (for IPv6 ACLs)• permit udp (for IPv6 ACLs)• seq (for IPv6 ACLs)• show ipv6 access-lists26IPv6 Access Control Lists (IPv6 ACLs) 1238
