Disabling unicast routing on an E-Series chassis causes the following behavior:• static and protocol learned routes are removed from RTM and from the CAM;packet forwarding to these routes is terminated• connected routes and resolved neighbors remain in the CAM and new IPv6neighbors are still discoverable• additional protocol adjacencies (OSPFv3 and BGP4) are brought down and nonew adjacencies are formed• the IPv6 address family configuration (under router bgp) is deleted• IPv6 Multicast traffic continues to flow unhinderedshow cam-ipv6 extended-prefixDisplay the currently configured and next-boot settings for extended IPv6 prefixes (/65 to /128) in LPM CAM.C9000 SeriesSyntax show cam-ipv6 extended-prefixDefaults NoneCommand Modes EXECEXEC PrivilegeCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.5(0.1) Introduced on the Z9500.9.3(0.1) Introduced on the S6000.Usage Information You can use this command to view the maximum number of extended IPv6 prefixentries supported in LPM CAM. The output displays the current value and the new valueapplicable after a switch reload.Example Dell#show cam-ipv6 extended-prefixCam-Ipv6-LPM Extended Prefix--------------------------------Current SettingsIPv6 Basics 1285
