Version Description9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.7.6.1.0 Introduced on the S-Series, S55.7.5.1.0 Introduced on the C-Series.Usage Information To block a type of message parameter, set the logging trap level to a lower number. Forexample, to block severity messages at level 6, set the level to 5.RelatedCommandslogging — enables the logging to another device.logging on — enables logging.logging versionDisplays syslog messages in a RFC 3164 or RFC 5424 format.C9000 SeriesSyntax logging version {0|1}Defaults 0Command Modes CONFIGURATIONCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.5(0.1) Introduced on the Z9500.9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.Usage Information To display syslog messages in a RFC 3164 or RFC 5424 format, use the log versioncommand in configuration mode. By default, the system log version is set to 0.The following describes the two supported log messages formats:• 0 – Displays syslog messages format as described in RFC 3164, The BSD syslogProtocolSimple Network Management Protocol (SNMP) and Syslog 2086
