3.3.14 Inspecting, signal lamp (option)Location of signal lampThe signal lamp is located as shown in this figure.Required equipmentNoteArt. no.Equipment, etc.To be replaced if damage is detected.See Spare parts onpage 565.Signal lamp kitContent is defined in section Stand-ard toolkit on page 559.-Standard toolkitThese procedures include referencesto the tools required.Other tools and procedures maybe required. See references tothese procedures in the step-by-step instructions below.Inspecting, signal lampUse this procedure to inspect the function of the signal lamp.NoteActionCheck that signal lamp is lit when motors are put inoperation ("MOTORS ON").1DANGERTurn off all:• electric power supply• hydraulic pressure supply• air pressure supplyto the robot, before entering the robot working area.2Art. no. is specified in Requiredequipment on page 136.If the lamp is not lit, trace the fault by:• Checking whether the signal lamp is broken.If so, replace it.• Checking cable connections.• Checking the cabling. Replace the cabling if afault is detected.3136 3HAC044266-001 Revision: -© Copyright 2013 ABB. All rights reserved.3 Maintenance3.3.14 Inspecting, signal lamp (option)
