Concluding proceduresNoteActionTightening torque: 10 Nm.xx1300000772Use caution and refit the wrist cover. In order notto damage the cable harness when the wrist coveris refitted, by following this method:1 Hold the cover in an angle. See figure!2 Catch any part of the cable harnesshanging down.3 Lift the cover, still held in an angle.4 Move the upper part of the cover into posi-tion.5 Secure the cover with its attachmentscrews.1See Updating revolution counterson page 542.Update the revolution counters.2DANGERMake sure all safety requirements are met whenperforming the first test run. These are furtherdetailed in the section DANGER - First test runmay cause injury or damage! on page 44.3234 3HAC044266-001 Revision: -© Copyright 2013 ABB. All rights reserved.4 Repair4.4.2 Refitting the cable harnessContinued
