Refitting the motorThese procedures describes how to refit the motor.Preparations prior to refitting motorNoteActionDANGERMake sure that all supplies for electrical power,hydraulic pressure, and air pressure are turnedoff.1Remove old paint residues and other contamina-tion from the contact surfaces on both motor andgearbox.2Wipe clean the contact surfaces from any remain-ing contamination.3Also wipe clean the o-ring groove.O-ring, 3HAB3772-107xx1200001019Check the o-ring.Replace if damaged!4xx1200001020Make sure the o-ring is seated in the groove.TipLubricate the o-ring with some grease for a betterfitting in the groove.5Continues on next page3HAC044266-001 Revision: - 401© Copyright 2013 ABB. All rights reserved.4 Repair4.7.2 Replacing the axis-2 motorContinued
