NoteArticle numberEquipment, etc.Used to secure lower arm.-Lock screw, M16x1203HAC9909-15Threaded bar, M16x340Included in the tool kit Dismantle andmounting tool (3HAC028920-001).3HAC047273-001Anvil3HAC020902-001Press tool, balancing deviceUsed for removing and fitting shaft andbearings.3HAC028920-001Dismantle and mounting toolTo be used with the hydraulic cylinder.3HAC13086-1Hydraulic pump 80 MPaLifting instruction 3HAC15880-2 en-closed.3HAC15556-1Lifting accessory (chain)SA-10-8-NA1-Lifting shackleContent is defined in section Standardtoolkit on page 559.-Standard toolkitConsumablesNoteArt. no.Equipment, etc.Optimol PD03HAC042534-001GreaseUsed for lubrication of thebearings at the cradle.Optimol PD0, 50 ml3HAC042534-001GreaseUsed for lubrication of thespherical roller bearing.Removing the balancing deviceUse these procedures to remove the balancing device.Unloading the balancing deviceNoteThe method described in this procedure using the distance tool(3HAC030662-001), is used when the same balancing device shall be refitted.If a new balancing device shall replace the removed one, another tool(3HAC020902-001 press tool balancing device) must be used! See Unloadingthe balancing device on page 379Continues on next page3HAC044266-001 Revision: - 355© Copyright 2013 ABB. All rights reserved.4 Repair4.6.2 Replacing the balancing deviceContinued
