NoteActionLifting shackle: SA-10-8-NA1xx1300000661Fit a lifting shackle to the balancing device.5Lifting accessory (chain): 3HAC15556-1Fit the lifting accessory to the shackle andraise to unload the weight.6Removing the shaft end, cradleThe procedure of removing the shaft end in the cradle is the same on both sides.NoteRemove one shaft end at a time!NoteActionxx1300000662Remove the VK cover by driving a screw-driver (or similar) through the VK cover, asclose as possible to the center of the VKcover. If not making a hole in the center ofthe VK cover, there is a risk of damagingthe bearing inside.NoteIt is almost impossible to remove the VKcover without damage. New VK covers areneeded.1Wipe off all residual grease inside the re-cess.2Continues on next page3HAC044266-001 Revision: - 371© Copyright 2013 ABB. All rights reserved.4 Repair4.6.3 Replacing the rear bearing of the balancing deviceContinued
