NoteActionApply some grease in the hole for thebearing in the cradle.2Threaded bar, M16x340: 3HAC9909-15xx1300000831Apply a threaded bar into the hole in thebalancing device.3xx1300000830Put sealing ring, radial sealing, spacer andgroove ball bearing onto the shaft endmanually.4Put the shaft end on the threaded bar.5Manually press the shaft end into the cradlea little.6Apply the press tool 3HAC027146-001 andhydraulic pump and nut on the threadedbar.7xx1300000838Before pressing the shaft end into position,put a big screw driver between the cradleand balancing device and use it as a dis-tance tool.8Use caution and press the shaft end in po-sition.9Remove the press tool and the threadedbar.10Apply some locking liquid (Loctite 243) onthe attachment screw.11Continues on next page3HAC044266-001 Revision: - 373© Copyright 2013 ABB. All rights reserved.4 Repair4.6.3 Replacing the rear bearing of the balancing deviceContinued
