3.4.3 Changing oil, axis-2 gearboxUsage of oil dispenserThe oil change procedure in this section describes usage of an oil dispenser.Location of oil plugsThe oil plugs of the gearbox are located as shown in the figure.xx1200000952xx1200000951Vent hole plug / level plugOil hole with nippleUsed for both draining and filling with an oildispenser.Tightening torque: 24 Nm.Required materialNoteMaterialInformation about the oil is found in Technical refer-ence manual - Lubrication in gearboxes.Lubricating oilSee Type and amount of oil in gearboxes on page 137.Required tools and equipmentNoteArticle numberEquipment, etc.The capacity of the vessel must besufficient to take the complete amountof oil.-Oil collecting vesselOne example of oil dispenser can befound in section Type of lubrication ingearboxes on page 137.-Oil dispenserContent is defined in section Standardtoolkit on page 559.-Standard toolkitContinues on next page3HAC044266-001 Revision: - 143© Copyright 2013 ABB. All rights reserved.3 Maintenance3.4.3 Changing oil, axis-2 gearbox
