Refitting the axis-6 motorUse this procedure to refit the motor.Preparations prior to refitting motorNoteActionDANGERMake sure that all supplies for electrical power,hydraulic pressure, and air pressure are turnedoff.1Remove old paint residues and other contamina-tion from the contact surfaces on both motor andgearbox.2Wipe clean the contact surfaces from any remain-ing contamination.3Also wipe clean the o-ring groove.O-ring, 3HAB3772-107xx1200001019Check the o-ring.Replace if damaged!4xx1200001020Make sure the o-ring is seated in the groove.TipLubricate the o-ring with some grease for a betterfitting in the groove.5Continues on next page444 3HAC044266-001 Revision: -© Copyright 2013 ABB. All rights reserved.4 Repair4.7.6 Replacing the axis-6 motorContinued
