System Id: F100.E120.0013 IS-Type: level-1-2Manual area address(es):49.0000.0001Routing for area address(es):49.0000.0001Interfaces supported by IS-IS:GigabitEthernet 1/0 - IP - IPv6GigabitEthernet 1/1 - IP - IPv6GigabitEthernet 1/10 - IP - IPv6Loopback 0 - IP - IPv6Redistributing:Distance: 115Generate narrow metrics: level-1-2Accept narrow metrics: level-1-2Generate wide metrics: noneAccept wide metrics: noneMulti Topology Routing is enabled in transition mode.FTOS#show isis trafficThis command allows you to display IS-IS traffic interface information.S4810Syntax show isis traffic [interface]Parameters interface (OPTIONAL) Identifies the interface type slot/port as one ofthe following:• For a 40-Gigabit Ethernet interface, enter the keywordfortyGigE then the slot/port information.• For a Gigabit Ethernet interface, enter the keywordGigabitEthernet then the slot/port information.• For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 128.• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet then the slot/port information.• For a VLAN, enter the keyword vlan then a number from1 to 4094.CommandModes • EXEC• EXEC PrivilegeCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Intermediate System to Intermediate System (IS-IS) 1017
