• For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 128.• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet then the slot/port information.• For a VLAN, enter the keyword vlan then a number from1 to 4094.hash-mask-length(OPTIONAL) Enter the hash mask length. The range is fromzero (0) to 32. The default is 30.priority (OPTIONAL) Enter the priority used in Bootstrap electionprocess. The range is from zero (0) to 255. The default iszero (0).Defaults Not configured.CommandModesCONFIGURATIONCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 6.1.1.0 Added support for the VLAN interface.ip pim dr-priorityChange the designated router (DR) priority for the interface.S4810Syntax ip pim dr-priority priority-valueTo remove the DR priority value assigned, use the no ip pim dr-prioritycommand.Parameters priority-value Enter a number. Preference is given to larger/higher number.The range is from 0 to 4294967294. The default is 1.Defaults 1PIM-Sparse Mode (PIM-SM) 1273
