Version 7.4.1.0 Introduced on the E-Series.bfd intervalSpecify non-default BFD session parameters beginning with the transmission interval.S4810Syntax bfd interval interval min_rx min_rx multiplier value role{active | passive}Parameters intervalmillisecondsEnter the keywords interval to specify non-default BFDsession parameters beginning with the transmission interval.The range is from 50 to 1000. The default is 100.min_rxmillisecondsEnter the keywords min_rx to specify the minimum rate atwhich the local system would like to receive control packetsfrom the remote system. The range is from 50 to 1000. Thedefault is 100.multiplier value Enter the keywords multiplier to specify the number ofpackets that must be missed in order to declare a sessiondown. The range is from 3 to 50. The default is 3.role [active |passive]Enter the role that the local system assumes:• Active — The active system initiates the BFD session.Both systems can be active for the same session.• Passive — The passive system does not initiate asession. It only responds to a request for sessioninitialization from the active system.The default is Active.Defaults Refer to Parameters.CommandModesINTERFACECommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.0.0 Introduced on the Z9000.Version8.3.19.0Introduced on the S4820T.Bidirectional Forwarding Detection (BFD) 361
