Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Introduced on the S-Series.Version 7.7.1.0 Introduced on the C-Series. Added 4-byte support.UsageInformationApplies to EBGP neighbors only.Configure your system to accept 4-byte formats before entering a 4 byte ASNumber.If the AS-PATH contains both public and private AS number or contains ASnumbers of an EBGP neighbor, the private AS numbers are not removed.If a confederation contains private AS numbers in its AS-PATH, the softwareremoves the private AS numbers only if they follow the confederation numbers inthe AS path.Private AS numbers are from 64512 to 65535 (2 byte).neighbor route-mapApply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.S4810Syntax neighbor {ip-address | peer-group-name} route-map map-name {in| out}To remove the route map, use the no neighbor {ip-address | peer-group-name} route-map map-name {in | out} command.Parameters ip-address Enter the IP address of the neighbor in dotted decimalformat.peer-group-nameEnter the name of the peer group.map-name Enter the name of an established route map.If the Route map is not configured, the default is deny (todrop all routes).in Enter the keyword in to filter inbound routes.out Enter the keyword out to filter outbound routes.NOTE: This command sends routes to peers only if anoutbound policy is configured and if there is a change inthe existing outbound policy.Border Gateway Protocol 431
