CommandModesCONF-CLASS-MAPCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.4.(0.0)Introduced on the S-Series and Z-Series.UsageInformationTo access this command, enter the class-map command. After the class map isidentified, you can configure the match criteria.Use this command to match an IP class-map against a single VRF ID .RelatedCommandsclass-map — identifies the class map.match mac access-groupConfigure a match criterion for a class map, based on the contents of the designated MAC ACL.S4810Syntax match mac access-group {mac-acl-name}Parameters mac-acl-name Enter a MAC ACL name. Its contents is used as the matchcriteria in the class map.Defaults noneCommandModesCLASS-MAPCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.2.1.0 Available on the C-Series and S-Series.Version 7.5.1.0 Added support for the DSCP Marking option.Quality of Service (QoS) 1343