Defaults Disabled.CommandModesINTERFACECommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.2.1.0 Introduced on S-Series Stacking.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.7.1.0 Introduced on the S-Series.Version 7.6.1.0 Introduced on the C-Series.Version 6.2.1.1 Introduced on the E-Series.UsageInformationWhen you enable sFlow on an interface, flow sampling is done on any traffic goingout of the interface.NOTE: After a physical port is a member of a LAG, it inherits the sFlowconfiguration from the LAG port.RelatedCommandssflow enable (Global) — turns sFlow on globally.sflow extended-switch enableEnable packing information on a switch only.S4810Syntax sflow extended-switch enableTo disable packing information, use the no sflow extended-switch [enable]command.Parameters enable Enter the keyword enable to enable global extendedinformation.1546 sFlow
