CommandModesEXEC PrivilegeCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.2.1.1Introduced on the E-Series.debug arpView information on ARP transactions.S4810Syntax debug arp [interface] [count value]To stop debugging ARP transactions, use the no debug arp command.Parameters interface (OPTIONAL) Enter the following keywords and slot/port ornumber information:• For a 1-Gigabit Ethernet interface, enter the keywordGigabitethernet then the slot/port information.• For the Management interface, enter the keywordManagementEthernet then the slot/port information.The slot range is from 0 to 1 and the port range is 0.• For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 128.• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet then the slot/port information.• For a 40-Gigabit Ethernet interface, enter the keywordfortyGigE then the slot/port information.• For a VLAN, enter the keyword vlan then a number from1 to 4094.IPv4 Routing 841
