CommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.Version 8.3.7.0 Introduced on the S4810.Version 8.3.1.0 Added the vlan option on the E-Series.Version 7.7.1.0 Introduced on the C-Series.Version 7.5.1.0 Added support for the violate-action and detailoptions.Version 6.5.1.0 Added support for Port Channel.Example Dell#show mac learning-limitInterface Learning Dynamic Static Unknown SASlot/port Limit MAC count MAC count DropsGi 1/0 10 0 0 0Gi 1/1 5 0 0 0Dell#show mac learning-limit interface gig 1/0Interface Learning Dynamic Static Unknown SASlot/port Limit MAC count MAC count DropsGi 1/0 10 0 0 0Virtual LAN (VLAN) CommandsThe following commands configure and monitor virtual LANs (VLANs). VLANs are a virtual interface anduse many of the same commands as physical interfaces.You can configure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN routing. FTP, TFTP,ACLs and SNMP are not supported on a VLAN.Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the VRRP state of a VLANinterface may continually switch between Master and Backup.NOTE: For more information, refer to VLAN Stacking and VLAN-related commands, such asportmode hybrid in the Interfaces chapter.Layer 2 1047
