CommandModesCONFIGURATIONCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.1.1.0Introduced on the E-Series.Example Dell#confDell(conf)# ip ssh rhostsfile flash://shostsDell(conf)#UsageInformationThis command specifies the rhost file used for host-based authentication. Thiscreates/ file overwrites the flash:/ADMIN_DIR/ssh/shosts file and deletesthe user-specified file. Even though this command is a global configurationcommand, it does not appear in the running configuration because you only needto run this command once.This file contains hostnames and usernames, for which hosts and users, rhost-authentication can be allowed.NOTE: For rhostfile and pub-key-file, the administrator must FTP thefile to the switch.ip ssh rsa-authentication (Config)Enable RSA authentication for the SSHv2 server.S4810Syntax ip ssh rsa-authentication enableTo disable RSA authentication, use the no ip ssh rsa-authenticationenable command.Parameters enable Enter the keyword enable to enable RSA authentication forthe SSHv2 server.1510 Security
