Parameters text Enter the description of the output policy. The maximum is32 characters.Defaults noneCommandModes • DCB INPUT POLICY• DCB OUTPUT POLICYCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version8.3.19.0Introduced on the S4820T.Version8.3.12.0Introduced on the S4810.Version8.3.16.0Introduced on the MXL 10/40GbE Switch IO Module.RelatedCommands • dcb-input — creates a DCB PFC input policy.• dcb-policy input — applies the output policy.• dcb-output — creates a DCBETS output policy.• dcb-policy output — applies the output policy.pfc link-delayConfigure the link delay used to pause specified priority traffic.S4810Syntax pfc link-delay valueTo remove the link delay, use the no pfc link-delay command.Parameters value The range is (in quanta) from 712 to 65535. One quantum isequal to a 512-bit transmission.Defaults 45556 quantumCommandModesDCB INPUT POLICYCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.522 Data Center Bridging (DCB)
