Version 8.4.2.1 Introduced on the C-Series and S-Series.Version 8.4.2.0 Introduced on the E-Series TeraScale.Version 7.5.1.0 Introduced on the E-Series ExaScale.redirectConfigure a rule for the redirect list.S4810Syntax redirect {ip-address | slot/port} {ip-protocol-number |protocol-type [bit]} {source mask | any | host ip-address}{destination mask | any | host ip-address} [operator]To remove this filter, use one of the following:• Use the no seq sequence-number command if you know the filter’ssequence number.• You can also use the no redirect {ip-address | slot/port} {ip-protocol-number [bit] | protocol-type} {source mask | any |host ip-address} {destination mask | any | host ip-address}[operator] command.Parameters ip-address Enter the IP address of the forwarding router.slot/port Enter the keyword slot / port followed by the slot/portinformation.ip-protocol-numberEnter a number from 0 to 255 for the protocol identified inthe IP protocol header.protocol-type Enter one of the following keywords as the protocol type:• icmp for internet control message protocol• ip for any internet protocol• tcp for transmission control protocol• udp for user datagram protocolbit (OPTIONAL) For the TCP protocol type only, enter one or acombination of the following TCP flags:• ack = acknowledgement• fin = finish (no more data from the user)• psh = push function• rst = reset the connection• syn = synchronize sequence number• urg = urgent fieldPolicy-based Routing (PBR) 1263
