debug ntpDisplay network time protocol (NTP) transactions and protocol messages for troubleshooting.S4810Syntax debug ntp {adjust | all | authentication | events | loopfilter| packets | select | sync}To disable debugging of NTP transactions, use the no debug ntp {adjust |all | authentication | events | loopfilter | packets | select |sync} command.Parameters adjust Enter the keyword adjust to display information on NTPclock adjustments.all Enter the keyword all to display information on all NTPtransactions.authentication Enter the keyword authentication to display informationon NTP authentication transactions.events Enter the keyword events to display information on NTPevents.loopfilter Enter the keyword loopfilter to display information onNTP local clock frequency.packets Enter the keyword packets to display information on NTPpackets.select Enter the keyword select to display information on the NTPclock selection.sync Enter the keyword sync to display information on the NTPclock synchronization.CommandModesEXEC PrivilegeCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.System Time and Date 1651
