Defaults Layer 3CommandModesCONFIGURATIONCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.UsageInformationUse this command to specify the name of the input QoS policy. Once input policyis specified, rate-police can be defined. This command enables the qos-policy-input configuration mode— (conf-qos-policy-in).When changing a Service-Queue configuration in a QoS policy map, all QoS rulesare deleted and re-added automatically to ensure that the order of the rules ismaintained. As a result, the Matched Packets value shown in the show qosstatistics command is reset.RelatedCommandsrate police — incoming traffic policing function.qos-policy-outputCreate a QoS output policy.S4810Syntax qos-policy-output qos-policy-nameTo remove an existing output QoS policy, use the no qos-policy-output qos-policy-name command.Parameters qos-policy-nameEnter your output QoS policy name in character format (32characters maximum).Defaults noneCommandModesCONFIGURATIONCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.Quality of Service (QoS) 1349
