interfaceinterfaceEnter the keyword interface then the interface type andslot/port or number information:• For a Fast Ethernet interface, enter the keywordfastEthernet then the slot/port information.• For a Port Channel interface, enter the keywords port-channel then a number.• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet then the slot/port information.• For a 40-Gigabit Ethernet interface, enter the keywordfortyGigE then the slot/port information.hardware_addressEnter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nnformat.Defaults noneCommandModesCONFIGURATIONCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.1 Introduced on the S4810.show ipv6 neighborsDisplay IPv6 discovery information. Entering the command without options shows all IPv6 neighboraddresses stored on the control processor (CP).S4810Syntax show ipv6 neighbors [ipv6-address] [cpu {rp1 [ipv6-address] |rp2 [ipv6-address]}] [interface interface]Parameters ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::xformat.NOTE: The :: notation specifies successive hexadecimalfields of zero.Neighbor Discovery Protocol (NDP) 1143
