Parameters access-list Enter the name of the extended ACL (16 charactersmaximum).Defaults Not configuredCommandModesINTERFACE (conf-if-interface-slot/port)CommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Introduced on the C-Series and S-Series.Version 7.6.1.0 Introduced on E-Series.UsageInformationThe access list accepted is an extended ACL. To block IGMP reports from hosts, ona per-interface basis based on the group address and source address that youspecify in the access list, use this feature.ip igmp group-join-limitTo limit the number of IGMP groups that can be joined in a second, use this feature.S4810Syntax ip igmp group-join-limit numberParameters number Enter the number of IGMP groups permitted to join in asecond. The range is from 1 to 10000.Defaults noneCommandModesCONFIGURATION (conf-if-interface-slot/port)CommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.2(0.0) Introduced on the M I/O Aggregator. This command issupported in Programmable-Mux (PMUX) mode only.712 Internet Group Management Protocol (IGMP)
