CommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.UsageInformationTo apply dot1p-queue-mapping, use the service-class dynamic dot1pcommand.RelatedCommandsshow qos dot1p-queue-mapping — displays the dot1p priority to queue mappingon the switch.service-class dynamic dot1pHonor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on allinterfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACEmode entry.S4810Syntax service-class dynamic dot1pTo return to the default setting, use the no service-class dynamic dot1pcommand.Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-classdynamic dot1p command. The default mapping is as follows:CommandModes • INTERFACE• CONFIGURATIONCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.1332 Quality of Service (QoS)
