deny tcp — assigns a filter to deny TCP traffic.ip access-list extendedName (or select) an extended IP access list (IP ACL) based on IP addresses or protocols.S4810Syntax ip access-list extended access-list-nameTo delete an access list, use the no ip access-list extended access-list-name command.Parameters access-list-nameEnter a string up to 140 characters long as the access listname.Defaults All access lists contain an implicit “deny any”; that is, if no match occurs, the packetis dropped.CommandModesCONFIGURATIONCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version8.3.10.0Introduced on the S4810.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.8.1.0 Increased the name string to accept up to 140 characters.Prior to 7.8.1.0, names were up to 16 characters long.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.2.1.1Introduced on the E-Series.UsageInformationThe number of entries allowed per ACL is hardware-dependent. For detailedspecification on entries allowed per ACL, refer to your line card documentation.Prior to 7.8.1.0, names are up to 16 characters long.232 Access Control Lists (ACL)
