CommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.4.(0.0)Introduced on the S-Series and Z-Series.UsageInformationUse this command on the interfaces where the DHCP clients are connected toforward the packets from clients to DHCP server and vice-versa.Example Dell(conf-if-fo-0/124)#ip helper-address vrf jay 10.0.0.2show ip dhcp snoopingDisplay the contents of the DHCP binding table or display the interfaces configured with IP Source Guard.S4810Syntax show ip dhcp snooping [binding | source-address-validation]Parameters binding Display the binding table.source-address-validationDisplay the interfaces configured with IP Source Guard.Defaults noneCommandModes • EXEC• EXEC PrivilegeCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.3.1.0 Introduced on the E-Series.Version 7.8.1.0 Introduced on the C-Series and S-Series.Dynamic Host Configuration Protocol (DHCP) 631
