CommandModesEXEC PrivilegeCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.4.(0.0)Added support for VRF.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Introduced on the S-Series.Version 7.7.1.0 Introduced on the C-Series.UsageInformationTo view information on both incoming and outgoing routes, do not include the inand out parameters in the debugging command. The in and out parameterscancel each other; for example, if you enter the debug ip bgp in command andthen enter the debug ip bgp out command, you do not see information on theincoming routes.Entering a no debug ip bgp command removes all configured debugcommands for BGP.RelatedCommandsdebug ip bgp events — views information about BGP events.debug ip bgp keepalives — views information about BGP keepalives.debug ip bgp notifications — views information about BGP notifications.debug ip bgp updates — views information about BGP updates.show debugging — views enabled debugging operations.debug ip bgp dampeningView information on routes being dampened.S4810Syntax debug ip bgp [vrf test | ipv4 {unicast | multicast} | ipv6{unicast | multicast} dampening404 Border Gateway Protocol
