CommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.4(0.0) Added support for VRF.Version 9.0.2.0 Introduced on the S6000.Version 9.0.0.0 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version8.3.19.0Introduced on the S4820T.UsageInformationTo clear Layer 3 CAM inconsistencies, use this command.CAUTION: Executing this command causes traffic disruption.RelatedCommandsshow ip fib stack-unit — shows FIB entries on a specified stack-unit.clear ip routeClear one or all routes in the routing table.S4810Syntax clear ip route [vrf vrf-name] {* | ip-address mask}Parameters vrf vrf-name (Optional) Enter the keyword vrf and then the name of theVRF to clear the routes corresponding to that VRF.* Enter an asterisk (*) to clear all learned IP routes.ip-addressmaskEnter a specific IP address and mask in dotted decimalformat to clear that IP address from the routing table.CommandModesEXEC PrivilegeCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.4.(0.0)Added support for VRF.Version 9.0.2.0 Introduced on the S6000.IPv4 Routing 839
