CommandModesINTERFACE VLAN — (conf-if-vl-n)CommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.2(0.0) Introduced on the M I/O Aggregator. This command issupported in Programmable-Mux (PMUX) mode only.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.E-Series legacycommand.UsageInformationDell Networking OS provides the capability of statically configuring the interface towhich a multicast router is attached. To configure a static connection to themulticast router, enter the ip igmp snooping mrouter interface commandin the VLAN context. The interface to the router must be a part of the VLAN whereyou are entering the command.ip igmp snooping querierEnable IGMP querier processing for the VLAN interface.S4810Syntax ip igmp snooping querierTo disable IGMP querier processing for the VLAN interface, use the no ip igmpsnooping querier command.Defaults Not configured.CommandModesINTERFACE VLAN — (conf-if-vl-n)CommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.2(0.0) Introduced on the M I/O Aggregator. This command issupported in Programmable-Mux (PMUX) mode only.730 Internet Group Management Protocol (IGMP)
