Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.2.1.1Introduced on the E-Series.RelatedCommandsline — applies an authentication method list to the designated terminal lines.ip access-list standard — names (or selects) a standard access list to filter based onthe IP address.ip access-list extended — names (or selects) an extended access list based on theIP addresses or protocols.enable passwordChange the password for the enable command.S4810Syntax enable password [level level] [encryption-type] passwordTo delete a password, use the no enable password [encryption-type]password [level level] command.Parameters level level (OPTIONAL) Enter the keyword level then a number as thelevel of access. The range is from 1 to 15.encryption-type(OPTIONAL) Enter the number 7 or 0 as the encryption type.Enter a 7 then a text string as the hidden password. The textstring must be a password that was already encrypted by aDell Networking router.Use this parameter only with a password that you copiedfrom the show running-config file of another DellNetworking router.password Enter a text string, up to 32 characters long, as the clear textpassword.Defaults No password is configured. level = 15.1456 Security
