32Link Aggregation Control Protocol (LACP)This chapter contains commands for Dell Networks’s implementation of the link aggregation controlprotocol (LACP) for creating dynamic link aggregation groups (LAGs) — known as “port-channels” in theDell Networking operating software. The LACP commands in this chapter are supported by DellNetworking OS on the S4810 platform.NOTE: For static LAG commands, refer to Port Channel Commands in the Interfaces chapter),based on the standards specified in the IEEE 802.3 Carrier sense multiple access with collisiondetection (CSMA/CD) access method and physical layer specifications.clear lacp countersClear port channel counters.S4810Syntax clear lacp port-channel-number countersParameters port-channel-numberEnter a port-channel number. The range is from 1 to 128.Defaults Without a Port Channel specified, the command clears all Port Channel counters.CommandModes • EXEC• EXEC PrivilegeCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.Link Aggregation Control Protocol (LACP) 1021
