-- Line card 4 --Current Settings(in block sizes)L2Acl : 2Ipv4Acl : 2Ipv6Acl : 4Ipv4Qos : 2L2Qos : 3Dell#show cam-aclRelatedCommandscam-acl — configures CAM profiles to support IPv6 ACLs.permit icmpTo allow all or specific internet control message protocol (ICMP) messages, configure a filter.S4810Syntax permit icmp {source address mask | any | host ipv6-address}{destination address | any | host ipv6-address} [message-type][count [byte]] | [log] [monitor]To remove this filter, you have two choices:• Use the no seq sequence-number command if you know the filter’ssequence number.• Use the no permit icmp {source address mask | any | host ipv6-address} {destination address | any | host ipv6-address}command.ParametersDefaults Not configured.CommandModesACCESS-LISTCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.7.0 Introduced on the S4810.Version 8.4.2.1 Introduced on the S-Series.Version 8.2.1.0 Introduced on the E-Series ExaScale.910 IPv6 Access Control Lists (IPv6 ACLs)
