CommandModesCONFIGURATIONCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.2.1.0 Introduced on S-Series Stacking.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.7.1.0 Introduced on the S-Series.Version 7.6.1.0 Introduced on the C-Series.Version 7.4.1.0 Introduced on the E-Series.UsageInformationSample-rate is the average number of packets skipped before the sample is taken.This command changes the global default sampling rate. You can configure aninterface to use a different sampling rate than the global sampling rate. If the valueentered is not a correct power of 2, the command generates an error messagewith the previous and next power of 2 value. Select one of these two packetnumbers and re-enter the command.RelatedCommandssflow sample-rate (Interface) — changes the interface sampling rate.sflow sample-rate (Interface)Change the interface default sampling rate.S4810Syntax sflow sample-rate valueTo return to the default sampling rate, use the no sflow sample-ratecommand.Parameters value Enter the sampling rate value. For the C-Series and S-Series,the range is from 256 to 8388608 packets. Enter values inpowers of 2 only; for example, 4096, 8192, 16384, etc. Thedefault is 32768 packets.1550 sFlow
