CommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.1.1.0Introduced on the E-Series.ntp multicast clientTo receive NTP information from the network via multicast, configure the switch.S4810Syntax ntp multicast client [multicast-address]To disable multicast reception, use the no ntp multicast client[multicast-address] command.Parameters multicast-address(OPTIONAL) Enter a multicast address. Enter either an IPv4address in dotted decimal format or an IPv6 address inX:X:X:X::X format. If you do not enter a multicast address, theaddress:• 224.0.1.1 is configured if the interface address is IPv4• ff05::101 is configured if the interface address is IPv6Defaults Not configured.CommandModesINTERFACECommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.1654 System Time and Date
