The S4810 supports both Ingress and Egress IP ACLs.NOTE: Also refer to the Commands Common to all ACL Types section.access-classApply a standard ACL to a terminal line.S4810Syntax access-class access-list-nameTo remove an ACL, use the no access-class access-list-name command.Parameters access-list-nameEnter the name of a configured Standard ACL, up to 140characters.Defaults Not configured.CommandModesLINECommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.8.1.0 Increase the name string to accept up to 140 characters.Prior to 7.8.1.0, names were up to 16 characters long.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.2.1.1Introduced on the E-Series.clear counters ip access-groupErase all counters maintained for access lists.S4810Syntax clear counters ip access-group [access-list-name]Access Control Lists (ACL) 207
