log-adjacency-changesGenerate a log messages for adjacency state changes.S4810Syntax log-adjacency-changesTo disable this function, use the no log-adjacency-changes command.Defaults Adjacency changes are not logged.CommandModesROUTER ISISCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version8.3.12.0Introduced on the S4810.Version 8.3.11.1 Introduced on the Z9000.UsageInformationThis command allows you to monitor adjacency state changes, which are usefulwhen you monitor large networks. Messages are logged in the system’s errormessage facility.lsp-gen-intervalSet the minimum interval between successive generations of link-state packets (LSPs).S4810Syntax lsp-gen-interval [level-l | level-2] interval seconds[initial_wait_interval seconds [second_wait_interval seconds]]To restore default values, use the no lsp-gen-interval [level-l |level-2] interval seconds [initial_wait_interval seconds[second_wait_interval seconds]] command.Parameters level-l (OPTIONAL) Enter the keywords level-1 to apply theconfiguration to generation of Level-1 LSPs.Intermediate System to Intermediate System (IS-IS) 991
