RelatedCommandsshow processes restartableredundancy auto-failover-limitSpecify an auto-failover limit for RPMs. When a non-recoverable fatal error is detected, an automaticRPM failover occurs. This command does not affect user-initiated (manual) failovers.S4810Syntax redundancy auto-failover-limit [count number [period minutes] |period minutes]]To disable the auto-failover limit control, use the no redundancy auto-failover-limit command.Parameters count number Enter the number of times the RPMs can automaticallyfailover within the period defined in the period parameter.The range is from 2 to 10. The default is 3.period minutes Enter a duration in which to allow a number of automaticfailovers (limited to the number defined in the countparameter). The range is from 5 to 9000 minutes. Thedefault is 60 minutes.Default • Count: 3• Period: 60 minutesCommandModesCONFIGURATIONCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version8.3.19.0Introduced on the S4820T.Version8.3.12.0Introduced on the S4810.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.5.1.0 Introduced on the C-Series.Version 7.6.1.0 Introduced on the E-SeriesHigh Availability (HA) 695
