Use the vrf attribute of this command to associate an access-list to a non-defaultVRF. You can use this command at the interface context (physical/LAG) to applythe access-list to a range of VRFs.The VRF MODE is not available for the default and management VRFs.RelatedCommandsip access-list standard — configures a standard ACL.ip access-list extended — configures an extended ACL.ip control-plane egress-filterEnable egress Layer 3 ACL lookup for IPv4 CPU traffic.S4810Syntax ip control-plane egress-filterDefaults Not enabled.CommandModesEXEC PrivilegeCommandHistory Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.show ip accounting access-listDisplay the IP access-lists created on the switch and the sequence of filters.S4810Syntax show ip accounting {access-list access-list-name | cam_count}interface interface [vrf vrf-name]Parameters access-list-nameEnter the name of the ACL to be displayed.cam_count List the count of the CAM rules for this ACL.interfaceinterfaceEnter the keyword interface then the one of the followingkeywords and slot/port or number information:• For a Port Channel interface, enter the keyword port-channel then a number. For the C-Series and S-Series,the range is from 1 to 128.• For a 1-Gigabit Ethernet interface, enter the keywordGigabitEthernet then the slot/port information.210 Access Control Lists (ACL)
