UsageInformationDCBX requires that you enable LLDP to advertise DCBX TLVs to peers.Configure DCBX operation at the INTERFACE level on a switch or globally on theswitch. To verify the DCBX configuration on a port, use the show interfacedcbx detail command.dcbx versionConfigure the DCBX version used on the interface.S4810Syntax dcbx version {auto | cee | cin | ieee-v2.5}To remove the DCBX version, use the dcbx version {auto | cee | cin |ieee-v2.5} command.Parameters auto | cee | cin| ieee-v2.5Enter the DCBX version type used on the interface, where:• auto: configures the port to operate using the DCBXversion received from a peer.• cee: configures the port to use CDD (Intel 1.01).• cin: configures the port to use Cisco-Intel-Nuova (DCBX1.0).• ieee-v2: configures the port to use IEEE 802.1az (Draft2.5).Defaults AutoCommandModesINTERFACE PROTOCOL LLDPCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version8.3.12.0Introduced on the S4810.Version8.3.16.0Introduced on the MXL 10/40GbE Switch IO Module.UsageInformationDCBX requires that you enable LLDP to advertise DCBX TLVs to peers.Data Center Bridging (DCB) 557
