Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.E-Series legacycommandUsageInformationMultiple logging servers of both IPv4 and/or IPv6 can be configured.RelatedCommandslogging on — enables the logging asynchronously to logging buffer, console,Syslog server, and terminal lines.logging trap — enables logging to the Syslog server based on severity.logging bufferedEnable logging and specify which messages are logged to an internal buffer. By default, all messages arelogged to the internal buffer.S4810Syntax logging buffered [level] [size]To return to the default values, use the default logging buffered command.To disable logging stored to an internal buffer, use the no logging bufferedcommand.Parameters level (OPTIONAL) Indicate a value from 0 to 7 or enter one of thefollowing equivalent words: emergencies, alerts,critical, errors, warnings, notifications,informational, or debugging. The default is 7 ordebugging.size (OPTIONAL) Indicate the size, in bytes, of the logging buffer.The number of messages buffered depends on the size ofeach message. The range is from 40960 to 524288. Thedefault is 40960 bytes.Defaults level = 7; size = 40960 bytesCommandModesCONFIGURATIONCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.2(0.0) Introduced on the M I/O Aggregator. This command issupported in Programmable-Mux (PMUX) mode only.1586 Simple Network Management Protocol (SNMP) and Syslog
