UsageInformationWhen you use the log option, the CP processor logs details about the packets thatmatch. Depending on how many packets match the log entry and at what rate, theCP may become busy as it has to log these packets’ details.NOTE: When ACL logging and byte counters are configured simultaneously,byte counters may display an incorrect value. Configure packet counters withlogging instead.RelatedCommandsdeny — configures a MAC ACL filter to drop packets.seq — configure a MAC ACL filter with a specified sequence number.IP Prefix List CommandsWhen you create an access-list without any rule and then apply it to an interface, the ACL behaviorreflects implicit permit.To configure or enable IP prefix lists, use these commands.clear ip prefix-listReset the number of times traffic mets the conditions (“hit” counters) of the configured prefix lists.S4810Syntax clear ip prefix-list [prefix-name]Parameters prefix-name (OPTIONAL) Enter the name of the configured prefix list toclear only counters for that prefix list, up to 140 characterslong.Defaults Clears “hit” counters for all prefix lists unless a prefix list is specified.CommandModesEXEC PrivilegeCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.262 Access Control Lists (ACL)
