UsageInformationIf you configure the set next-hop command, its configuration takes precedenceover the neighbor next-hop-self command in the ROUTER BGP mode.If you configure the set next-hop command with the interface’s IP address(either Loopback or physical), the software declares the route unreachable.RelatedCommandsmatch ip next-hop — redistributes routes that match the next-hop IP address.set originTo manipulate the BGP ORIGIN attribute, configure a filter.S4810Syntax set origin {igp | egp | incomplete}To delete an ORIGIN attribute setting, use the no set origin command.Parameters egp Enter the keyword egp to set routes originating from outsidethe local AS.igp Enter the keyword igp to set routes originating within thesame AS.incomplete Enter the keyword incomplete to set routes withincomplete routing information.Defaults Not configured.CommandModesROUTE-MAPCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.292 Access Control Lists (ACL)
